The water tank is short of water

The icon    turns red on display panel of machine, indicating that the water tank is short of water in air-conditioning mode.

Problem-shooting
    When the water tank is short of water, the float in the water tank makes the magnetic switch close, thus giving an alarm.

Step 1: Add water into water tank.

Step 2: If the water float is stuck, it can be moved by using inertia with shaking the tank; Or you can use vibration to make the water float move bytapping the water tank gently.

Step 3: If the tank is full of water and the float is not stuck, please contact the service center for help.

The water tank is full of water

The icon    turns red on display panel of machine, indicating that the water tank is full of water in Dry mode.

Problem-shooting
    When the water tank is full of water, the float in the water tank makes the magnetic switch disconnect, thus giving an alarm.

Step 1: Empty the water tank.

Step 2: Float is stuck, causing wrong error code. It can be moved by using inertia with shaking the tank; Or you can use vibration to make the water float move by tapping the water tank gently.

Step 3: If the tank is empty and the float is not stuck, please contact the service center for help.

[P3] Over the temp limit

Error code [P3] appears on display panel of machine, indicating that the current ambient temperature T < 16 or T > 40 is detected for 60s in the AC and DRY mode.

Problem-shooting

Step 1: If the temperature is out of the range of 16-40 in order to protect your machine, it is not allowed to start the AC and dry modes. It is a normal phenomenon.

Step 2: If the temperature is with the range of 16-40 , but error code does not disappear, please contact service center for help.

[E8] The water tray is full

Error code [E8] appears on display panel of machine, indicating that the full water of the water tray is detected for 5s in all modes.

Problem-shooting

Step 1: Find a container to collect water and place it under the water outlet.

Step 2: Unscrew the drain cap and gently pull out the rubber plug. Drain until no water comes out.

Step 3: After draining the tray, if error code does not disappear, please contact service center for help.

Filter dust full reminder

The icon   turns red on display panel of machine, indicating that the machine runs for more than 250 hours. In order to remind the user to clean the filter screen in time.

Problem-shooting

Step 1: Please refer to procedure on page 19~20 to clean the filter screens.

Step 2: Press and hold the “Timer/Light” button for 3s, the indicator light will go out.

Other abnormal alarm: [E1] [E2] [E3] [E6] [E7]

When error code [E1], [E2], [E3], [E6], [E7] appears on display board, it means that internal sensors or motors have some kinds of problem. Please reconnect the plug and restart the machine. If the error code doesn't disappear, please contact service center for help.

Problem-shooting

[E1]: In cooling and DRY mode, if the speed of condensing DC motor is abnormal, the machine will display the error code [E1].

[E2]: In all modes, if the speed of condensing DC motor is abnormal, the machine will display the error code [E2].

[E3]: In cooling mode, if the current or frequency signal of the water pump motor is abnormal, the machine will display the error code [E3].

[E6]: In all modes, if the evaporator NTC is short-circuited or opencircuited, the machine will display the error code [E6].

[E7]: In all modes, if the temp and humidity sensor is detected to be open or short-circuited,the machine will display the error code [E7].